Starlink Gen 2 Replacement Cable — Shielded CAT5e FTP, 24 AWG, 1 Gbps, 2–46 m
A pre-terminated replacement cable for Starlink Gen 2 / V2 Standard systems. It runs straight from the dish to the router — no field termination, no crimping. Pick 2 m, 10 m, 15 m, 23 m, 30 m or 46 m to fit your route.
When a Gen 2 cable is damaged, too short, or needed as a spare, this is the drop-in replacement. Both ends come factory-terminated with moulded Gen 2 plugs — one angled end for the dish mast, one straight end for the router. Plug the dish end into the dish, the other end into the router, and the link is back. The cable is 24 AWG CAT5e FTP with 8 copper conductors plus a ground wire, Mylar and aluminium-foil shielding, and a weather-resistant PVC jacket. It is built for data up to 1 Gbps with matching Gen 2 equipment and a correct install. Moulded strain relief at each plug guards the spot where the cable bends most. Use it for a new install, a maintenance swap, or as an installer spare. The six lengths cover short indoor links and long outdoor runs across homes, cabins, farms, workshops, RV parks and remote offices. One picture labels the 75 ft (23 m) version for the Gen 2 dish.
Key facts
- Cable: 24 AWG CAT5e FTP, 8 copper conductors plus ground
- Shielding: Mylar and aluminium foil
- Jacket: PVC, weather-resistant
- Speed: up to 1 Gbps
- Connectors: moulded Gen 2-compatible plugs, both ends (angled dish end, straight router end)
- Lengths: 2 m, 10 m, 15 m, 23 m, 30 m, 46 m
- Product series in source files: XL-V2 Standard Cable Series
- Third-party compatible accessory, not an official SpaceX product. Starlink is a trademark of SpaceX.
Compatibility
Fits Starlink Gen 2 / V2 Standard Actuated systems. Check Gen 2 fit before ordering.
Application scenarios
- Gen 2 residential and small-business installs
- Replacing a worn or damaged dish-to-router cable
- RV, camper, cabin and mobile-work setups
- Remote offices, farms, workshops and surveillance sites
- Spare-cable kits for installers and field service teams