Blog

November 12, 2026

Starlink Gen 3 Cable Length: How to Pick 2 m, 10 m, 23 m or 46 m

The most common mistake with a Starlink Gen 3 cable is buying the wrong length. Too short and you end up with a dish that can’t reach the router, or a cable pulled tight across a corner. Too long and you’ve got a coil of spare cable sitting behind the TV that nobody wants to look at.

Our Gen 3 replacement cable comes in six lengths: 2, 10, 15, 23, 30 and 46 metres. Same cable in every size — shielded CAT5e FTP, 24 AWG, factory-terminated Gen 3 plugs on both ends, good for up to 1 Gbps — so the only decision is how much of it you need.

Don’t measure the straight line from the dish to the router. Measure the route the cable will actually take: down off the roof, around the eave, in through the wall, along the skirting board to where the router lives. Then add a metre or two. That slack is what lets you form a drip loop outside, move the router to another socket later, or re-route around a bracket without starting over.

A rough guide:

  • 2 m — the router sits right by the entry point, or it’s a temporary setup in the RV. Short, tidy, nothing left over.
  • 10–15 m — the usual house install. Dish on the roof edge, router a room or two in. This is where most people land.
  • 23–30 m — the dish is on the far side of the roof, up a pole, or the router lives deep in the house.
  • 46 m — long runs to an outbuilding, a barn, or a dish mounted well away from the house.

If you’re between two sizes, take the longer one. A little extra cable coiled loosely out of sight is fine; a cable that’s 50 cm short is a second order and another afternoon on the roof.

Two things worth knowing before you order. First, this cable only fits the Standard Gen 3 dish — the plugs are different on Gen 2, so if you’re running the older actuated dish, you want the Gen 2 replacement cable instead. Second, if you already have a Gen 3 cable run in place and it’s just short, you don’t have to replace the whole thing: our Gen 3 RJ45 adapter pair lets you extend it with a cable of your own.

Measure the route, not the gap. Add slack. Pick the next size up if you’re torn. That’s the whole trick.

gerry Uncategorized
User avatar
About gerry
Gerry is with JINSHANG electronic tech(FEV Electronics), a cable manufacturer in Changzhou, China. The team makes Car amplifier Installation wiring kits(car audio cables), Starlink Gen 3, Gen 2 and Mini replacement cables, adapters, power cables and roof mounts, and customized cable assemblies for medical, industrial, consumer and automotive use. He writes here about picking the right cable for the job — lengths, power, mounts — and what actually works in the field.