If your Starlink bill went up this month, you are not imagining it — and your dish has nothing to do with it. On 7 November, Starlink subscribers in Virginia, Louisiana, North Carolina, Washington and Alaska started getting rate-increase emails. A week earlier the same model had debuted in Kansas, Missouri and Nebraska. Now it is the national pricing model for Residential service.
What actually changed
Starlink now sets your monthly rate by how crowded the network is above your home. Where the local cell is congested, prices rise 10% to 20%. Residential Max goes from $130 a month to as much as $156 — an extra $312 a year for the same dish, the same speeds, the same sky. This is the second increase of 2026 for affected subscribers, after a $5 to $10 rise back in May.
The same system cuts prices where capacity is spare. New customers in Boston, San Francisco and New York City are being offered 30% to 50% off, with Boston checkout showing the 100 Mbps tier at $27.50 a month. SpaceX tells those customers the price applies for as long as the subscription stays active. Two people on the same plan can now pay very different amounts, depending on how busy the sky is above their homes.
Starlink’s terms require 30 days’ notice before a plan price change takes effect, so check your inbox — the increase lands on your next bill, not the one after. When the model launched, SpaceX told Kansas and Missouri customers it would review prices “roughly quarterly.” The nationwide notice drops that schedule and says only that prices may change from time to time. How often they will actually move, nobody outside SpaceX knows yet.
What it does not change
Nothing about the hardware. No new dish, no new cable, no new mount is needed because of a pricing change — the dish you already own is the same dish. If your bill went up, the worst response is to make it worse by replacing working gear or buying the wrong part in a hurry. A cable that was the right length last month is still the right length. A mount that held through the last storm still holds.
And if you are one of the new customers signing up in a discounted city, the kit still ships with a short standard cable. Before you order anything extra, measure the run from the dish to the router — roof to room, around the eaves, with slack for the drip loop — and buy the length that fits the route, not the one that looks about right. Our Gen 3 replacement cable comes in 2, 10, 15, 23, 30 and 46 m, shielded (CAT5e FTP, 24 AWG, 1 Gbps), so the run can go the proper way round the house instead of the shortest way across a roof.
Two things worth doing this week
First, check your exact address on Starlink.com. Your rate is set by your local cell, and the site shows the current price for your location whether you subscribe or are still shopping. Second, if you already subscribe and your area just got dearer, it is worth asking Starlink support what applies to your address. PCMag reported on 9 November that some existing customers who asked got a lower rate or a one-time credit — it is not a published offer, results vary, and one reported reduction was reversed a few days later, so treat it as a question worth asking, not a discount you are owed.
SpaceX says the model cuts both ways: as capacity expands, prices in your area may come down. That relief depends on new satellites — the larger V3 generation — catching up with demand where you live, which is a mid-2027 story, not a next-month one. Until then, the bill moves with your neighbours. The hardware doesn’t have to.
Sources: PCMag, “‘WTF Is This Price Increase?’ Starlink’s Surge Pricing Expands, Igniting Backlash” (7 Nov 2026); TechSpot, “Starlink expands surge-style pricing model with increases of up to 20%” (8 Nov 2026); SatellitePlan, “Starlink’s dynamic pricing goes nationwide” (9 Nov 2026); PCMag, “Want Cheaper Starlink? Try Asking Its Grok AI-Based Customer Support” (9 Nov 2026).

