Starlink Gen 3 Large-Diameter Pipe Adapter — Fits 1.25″–2.5″ Pipes
A molded pipe adapter that lets a Starlink Gen 3 / V3 Standard dish sit on a pole or mast. Take the stock Gen 3 bracket off the back of the dish, fit this adapter in its place, slide it over a pipe 1.25" to 2.5" in diameter, and lock it with the setting screws. The pipe itself is not included.
This adapter is the link between a Gen 3 dish and a pipe you already have. The stock bracket comes off the back of the dish, this adapter goes on in its place, and the whole thing drops onto a mast, pole, or roof-support pipe. Two setting screws bite into the pipe and hold it in place. An Allen key for those screws is in the box. The opening takes pipes from 1.25″ to 2.5″ in diameter. Measure your pipe first — anything outside that range will not fit. The adapter body is molded PC / engineering plastic, in grey. It has routing holes for the cable: a hollow pipe can run the cable up through the inside, and a solid pipe can run it through the outside slot. The box also has 20 cable routing clips for fixing the cable run to a wall. Each clip measures about 20 mm x 10 mm x 8 mm. One thing to sort out before this page goes live: the source files disagree on the tilt angle. The TXT files say about 8 degrees. One of the images says 20 degrees. Do not print either number as fact until the supplier confirms which one is right — see the warning below.
Key facts
- Fits: Starlink Gen 3 / V3 Standard terminal (see compatibility note below)
- Pipe size: 1.25″–2.5″ diameter (from the images; the TXT files give no pipe size)
- Material: molded PC / engineering plastic
- Angle: CONFLICT — TXT says about 8 degrees; image says 20 degrees. Not confirmed.
- Cable routing: external routing hole for solid pipes, internal routing holes for hollow pipes
- Support: three-point support design inside the adapter opening
- Colour: grey (as shown in the images)
- Pipe / mast: NOT included. The buyer supplies the pipe.
In the box
- Pipe adapter mount x 1
- Setting screws x 2
- Allen key x 1
- Cable routing clips x 20
Compatibility
Fits the Starlink Gen 3 / V3 Standard dish. Does NOT fit, according to the compatibility image: Flat High Performance, High Performance, Mini, and Standard (Gen 2).
Note on the dish name: one source image labels the compatible dish “Standard Actuated Gen 3”. That wording is not used here — the Gen 3 Standard dish is the fixed, non-actuated model, and Gen 2 is the actuated one. Confirm the correct dish name with the supplier before ordering.
Warning — tilt angle not confirmed: the source files disagree on the tilt angle. The TXT files say about 8 degrees; one of the images says 20 degrees. Do not treat either number as fact until the supplier confirms which one is right.
This is a third-party compatible accessory, not an official SpaceX product. Starlink is a trademark of SpaceX.
Application scenarios
- Pole and mast installs where a pipe is already in place
- Roof-support pipes on homes, cabins, farms, and remote offices
- RV, trailer, and boat mounts on an existing pipe or rail post
- Replacement adapter for a Gen 3 install that already has a mast