Starlink Gen 2 Adjustable Aluminum Pivot Roof Mount
A die-cast aluminum pivot mount for a Starlink Gen 2 / V2 dish. The base bolts to a shingled roof or a wall, the arm pivots through 90 degrees, and the dish's own pole drops into the socket and locks with a clamping knob. Sealing tape, screws, wall clips, and a manual are in the box.
This mount gives a Gen 2 dish a fixed spot up high instead of sitting on the ground. The base is die-cast aluminum alloy, about 8.58 in long and 4.25 in wide, and it bolts down with two lag screws. Sealing tape goes into the drilled holes first, and adhesive pads sit under the base, so water stays out of the roof. The arm pivots through 90 degrees. Set the angle that suits the roof slope, then turn the big knob clockwise until it locks. The Gen 2 dish’s own pole slides into the socket on top of the arm — there is no separate mast in the box — and a small screw clamps it tight. The same base also bolts to a vertical wall, for example a fascia board or a brick wall, and the pivot lets the dish sit level from there too. Before a wall install, check the clearances in the warning image: the dish needs room to turn without hitting the roof, and if the building has overhanging eaves, use shims on the fascia board. The box has 40 wall clips for the cable run, which is twice as many as the Gen 3 kit’s 20. The TXT files just say “cable clips” with no count; the 40 comes from the package image.
Key facts
- Fits: selected Starlink Gen 2 / V2 terminal posts
- Material: die-cast aluminum-alloy base and support structure
- Adjustment: pivot turns through 90 degrees
- Base size: 8.58 in long x 4.25 in wide x 6.22 in tall
- Install: drilled attachment on a suitable shingled roof; drilling and roof sealing are required
- Do not use on tile, slate, clay, or unsuitable substrates without an approved method
- Wall-mount clearances: more than 3.9 in / 100 mm between the dish and the roof edge, more than 0.78 in / 2 cm between the post and the roof ridge
- Colour: dark grey (as shown in the images)
In the box
- Pivot mount (base with socket arm) x 1
- Bracket screws x 2
- Sealing tape x 2 (large strip) + x 2 (small square)
- Wall clips x 40
- Installation manual x 1
Note: no Allen key or mast is shown in this box, unlike the Gen 3 kit.
Compatibility
Fits Starlink Gen 2 / V2 terminal posts (“Compatible with Starlink Gen 2”). Compatibility with other dishes is not stated in the source files: the source files do not say whether it fits Gen 3, Mini, or High Performance dishes.
This is a third-party compatible accessory, not an official SpaceX product. Starlink is a trademark of SpaceX.
Application scenarios
- Fixed Gen 2 installs on residential shingled roofs
- Cabins, workshops, farm buildings, and remote offices
- Fixed RV shelters and other permanent structures
- Wall mounts on fascia boards and brick walls where the roof itself is not suitable
- Professional replacement or upgrade installs for Gen 2 dishes still in service